Continuous estimation of 3-D reflector orientations along 2-D deep seismic reflection profiles
Back to previous page
| Authors: | Calvert, AJ |
| Year: | 2017 |
| Journal: | Tectonophysics 718: 61-71 Article Link (DOI) |
| Title: | Continuous estimation of 3-D reflector orientations along 2-D deep seismic reflection profiles |
| Abstract: | Interpretation of 2-D deep seismic reflection data can be limited by the recording of out-of-plane reflections that cannot be readily distinguished from those originating beneath a seismic line. Here I present a method analogous to semblance velocity analysis that utilizes varying source-receiver azimuths to derive continuous estimates of 3-D reflector orientations along onshore 2-D reflection profiles. For each zero-offset time within a common depth point supergather, the semblance is calculated along 3-D travel time curves, and the dip and strike of the most coherent reflection is determined. Relative errors in these angles are derived from the range of travel time curves that have semblance values greater than a specified fraction, for example 90%, of the maximum. The method is illustrated Using a section from line 10GA-YU1 from the Youanmi terrane of the Yilgarn craton in Australia in which the original field data have been replaced with synthetic in-line and cross-line reflections. Reflector orientations are generally well recovered where the range of available source-receiver azimuths is greater than 20 degrees, but the method fails at lower ranges where the seismic line is almost linear, and this behavior is also observed in analysis of the field data. Nevertheless when using a realistic 1-D velocity function the orientation of upper crustal shear zones can be readily determined, and on unmigrated sections subhorizontal sills can be distinguished on the basis of their geometry from the mid-crustal reflectivity. In future surveys, reflector orientations can be determined along the near-linear sections of a seismic profile by deploying additional receivers, perhaps as cross-line recording spreads, to supplement the limited range of azimuths available from the in-line acquisition. The method can in principle be extended to marine reflection surveys, and more complex sub-surface velocity models. (C) 2016 Elsevier B.V. All rights reserved. |
Departmental members may update their publication list.